Nicholas D
New member
- Joined
- Dec 19, 2009
- Messages
- 1
- Reaction score
- 0
- Points
- 0
V2500 5.7l fuel injected - throttle body. Just completed tune up with new plugs wires cap rotor, air filter, oil change. Cleaned Idle air control valve(wasn't that Bad). Also replaced electronic spark control module and Map sensor as well as a few bad vacuum lines. I had a code for the map and now its gone after test drive. I also set the timing(with the connector disconnected) to 0 degrees. I have two scan tools and I am using all-data pro and I'm still having trouble. I'm going to change the fuel filter as well, just to complete tune up. Engine sounds like it's gasping for air and heavy smell of fuel from throttle body. High rpm engine runs fine. Also put in bottle of dry gas just in case.