cobalt 2009 camshaft sensor

2

2009cobalt

New member
Joined
Jun 9, 2013
Messages
2
Reaction score
0
Points
0
At my wits end i changed the camshaft sensor because i got a code P0010
and p0011 .engine light still on even after it was cleared by taking off the neg post on battery.same codes. Is the c02 sensor related or whats next to do.
:confused:
 
How long did you disconnect the battery? I THINK you have to leave it disconnected for at least two minutes, but I'm not a mechanic by trade. Maybe there are a certain number of drive cycles you have to go through before the code clears.
 
There are drive cycles or you need a scanner with reset ability
 
auto zone cleared it but still appeared.Drive cycles whats the thurshhold 60mph speed.
or 3 thousand miles.
 
Not sure on the drive cycles. I think they vary from car to car. How's the car running? If it's running right, I wouldn't worry to much about the frigging light unless inspection is coming up soon.
 
You must log in or register to reply here.

Share this page

Back
Top